Please be informed that on our website we use cookies and other similar technologies for the purposes of the provision of services. Using the website without changing your browser settings means that they will be placed on your terminal equipment. You can change these settings, learn more from Privacy Policy.

Hx8872-c Datasheet <HOT ⚡>

// Assume LCD_RST, LCD_CS, LCD_RS (D/C) defined void HX8872C_Init(void) // Hardware reset HAL_GPIO_WritePin(LCD_RST_GPIO_Port, LCD_RST_Pin, GPIO_PIN_RESET); HAL_Delay(10); HAL_GPIO_WritePin(LCD_RST_GPIO_Port, LCD_RST_Pin, GPIO_PIN_SET); HAL_Delay(120); // Send commands via SPI or MCU interface WriteCommand(0x11); // Sleep out HAL_Delay(120); WriteCommand(0x36); WriteData(0x00); // Normal orientation WriteCommand(0x3A); WriteData(0x05); // 16-bit RGB WriteCommand(0x29); // Display on

In RGB mode, yes. The HX8872-C has no internal RAM; it refreshes directly from the incoming pixel stream. Your MCU must continuously send data. hx8872-c datasheet

| Command (Hex) | Function | Parameter Bytes | | :--- | :--- | :--- | | 0x01 | Software Reset | None | | 0x11 | Sleep Out (Exit Sleep Mode) | None (wait 120ms) | | 0x29 | Display ON | None | | 0x36 | Memory Access Control (orientation) | 1 byte (MX, MY, MV bits) | | 0x3A | Interface Pixel Format | 1 byte ( 0x05 =16-bit, 0x06 =18-bit) | | 0x2A | Column Address Set | 4 bytes (start/end col) | | 0x2B | Row Address Set | 4 bytes (start/end row) | | 0x2C | Write Memory (RAM data write) | Variable (pixel data) | A typical initialization sequence from the datasheet would look like: // Assume LCD_RST, LCD_CS, LCD_RS (D/C) defined void

Introduction: Why the HX8872-C Matters In the world of display technology, the bridge between a processor and an LCD panel is often a critical, yet overlooked, component. The HX8872-C is one such component—a specialized LCD driver IC designed by Himax Technologies. While many drivers fade into obsolescence, the HX8872-C remains a relevant solution for specific embedded systems, legacy hardware repairs, and cost-sensitive TFT display modules. | Command (Hex) | Function | Parameter Bytes

Check VSYNC and HSYNC polarity. The datasheet indicates that the HX8872-C can accept positive or negative edges, but you must configure the “Display Timing Control” register (0xB0) accordingly.

Yes – revision C has a minor issue with charge pump startup at low temperatures (< -20°C). Add a 1µF capacitor close to the VCI pin. Conclusion: Your Roadmap to Success with the HX8872-C The hx8872-c datasheet is more than a list of electrical specs—it is the definitive guide to unlocking the potential of a capable, albeit older, LCD driver. Whether you are repairing a legacy system or building a custom retro-gaming handheld, understanding this IC’s timing diagrams, power sequencing, and command set will save you weeks of debugging.

// Then configure LTDC peripheral for RGB interface: // HSYNC = 10, HBP = 20, HFP = 10, VSYNC = 2, VBP = 2, VFP = 2 // Pixel clock = 9MHz Q1: Is the HX8872-C compatible with 1.8V logic systems? Yes. The digital I/O pins can operate at 1.8V as long as VDDIO is supplied at 1.8V.